Workshop Update: At the Lathe

Since I finished up a few flatwood projects, I have returned to my turning addiction, including some hollowing and a Holiday project with the kids. The round carbide bits that I mentioned in the video are available at here. What is nice is that they also sell the proper screws, and even the taps for the screws. I was a little off on the prices, but still far cheaper than buying "replacement cutters" from turning catalogs. If you have not used carbide cutters before and are not sure what size to start with, start with the 10mm (which is approximately 3/8").

Did you find this video valuable? Click here to buy me a shot of espresso